Honglida International trade > News > Encyclopedia > Use and use method of rubber edge trimming machine
Use and use method of rubber edge trimming machine
2015-03-20 14:50:05 Author:SystemMaster Source: Font size:[Large][Middle][Small]

Rubber trimming machine is mainly used for rough edges of rubber products after processing automation, plastic intake pruning automation;

The method of operation:

   Rubber remove edge machine is divided into investment and silo, bin and a material bin work, separation or remove the input side rubber products need to vote in the bunker, for closing the door operating instructions on the operation panel, remove the side rubber chance automatically remove edge rubber products, separation of a series of work, carried out in a material in the bunker, separation and rubber products, the whole operation is safe, rapid, feeding and seamless docking, just feeding can be continuous flow process.

Characteristics:

  ●High production efficiency, an automatic disassembly machine processing edge day equivalent to the amount of 20-100 skilled workers hook flash workload (rubber and plastic products is small, the greater production capacity, especially suitable for a 3mm-80 diameter mm). Rubber remove edge machine can automatically control the removed edge speed and time, so that the entire operation process of the intelligent, the work efficiency is 20-1000 times higher than manual operation, each machine 10 hours processing small miscellaneous pieces of rubber above 15000000 PCs, the separation rate of more than 99%, after processing, product deformation, damage.

  ●Automatically remove edge to edge machine, remove the stable quality of the precision of edge and the qualified rate was significantly higher for manual operation (the traditional manual hook flash, flash, slow speed more scratching, snag, mixed goods, dirty and so serious).

  ●Comparison of frozen repair side machine price is higher, the use of low cost, power consumption per hour less than 4 degrees, do not need to use liquid nitrogen, and the equipment price is much lower than the frozen trimming machine or import equipment. The processing of any rubber products, need not die and the efficiency is higher than that of stamping burr way.

  ●The machine is divided into investment and silo and a working bin, feeding and seamless docking, each without shutdown restart action, just feeding can be continuous flow process. The whole process using numerical control frequency conversion control, easy to understand, more intuitive and convenient, operation more accurate, safe. Ordinary workers after half an hour of training can operate independently.