Honglida International trade > News > Encyclopedia > Rubber remove the installation and debugging of edge machine
Rubber remove the installation and debugging of edge machine
2015-03-20 15:11:41 Author:SystemMaster Source: Font size:[Large][Middle][Small]

One, Installation method, rubber remove edge machine

1, will be placed in the ventilation machine;

2, the anti power protection devices play in cleaning up the position;

3, connected the 380V three-phase / three wire power and grounding wire (yarn);

4, the machine back air filter pipe connecting mouth connected with 8mm pipe;

5, turn on the power, whether the leakage detection machine.

Two, rubber demolition technology edge machine parameters:

1, the motor power:50Hz/4kw

2, voltage:380 V

3, the frequency converter:5.5PH

4, volume:50 L

5, suitable for processing products: rubber, silicone, fluorine rubber products, plastic parts (soft)

6, workpiece size range: thickness of more than 0.35mm, diameter is less than 150mm

7, air pressure rating:0.8 Mpa

8, the appearance of equipment size: 1520*570*1150 MM (length * width * height)

9, the weight of equipment:380 kg;

Added: anti power safety protection device, constant temperature device;

Three, rubber screening method of installation machine

1, will be placed in the ventilation machine;

2, on the position machine foot bolt hole is provided with 4 fixed bolts, locking the machine on the ground;

3, the 220V plug (a grounding copper sheet) inserted in the anti leakage socket;

4, turn on the power, whether the leakage detection machine.